Toro Sand Pro 3040 Service Manual page 230

Removing the Front Wheel (continued)
Installing the Front Wheel
Chassis: Service and Repairs
4. Loosen the set screw on the bearing locking collar.
5. Remove the fasteners securing the bearing assembly and bearing tab to
the front fork.
6. Remove the fasteners securing the hydraulic motor to the fork.
Support the wheel and motor assembly when raising the front of the
machine to prevent hydraulic tube damage.
7. Raise the front of the machine slowly until the wheel and motor assembly can
be removed from the fork. Support the machine with appropriate jack stands.
8. Slide the bearing assembly from the spindle. Separate the flangettes from
the bearing.
9. For model 08743 machines, remove the wheel weight.
A. Remove the 2 lock nuts and thrust washers that secure the wheel weight
to the wheel, and carefully slide the wheel weight from the studs.
B. Remove the wheel weight adapters with studs.
10. Remove the lug nuts and remove the wheel from the motor and hub assembly.
11. Separate the spindle from the wheel motor and hub assembly.
12. Secure the wheel motor and hub assembly to the fork with the previously
removed fasteners to prevent damaging the hydraulic lines.
13. If wheel motor or hub removal is necessary, refer to
Wheel Motor (page
Refer to Figure 89 for this procedure.
1. Fit the spindle over the hub drive studs and install the wheel.
2. Install the lug nuts and tighten them evenly in a crossing pattern from 95
to 122 N·m (70 to 90 ft–lb).
3. For model 08743 machines, install the wheel weight.
A. If the studs were removed from the wheel weight adapters, thread studs
all the way into the correct end of the adapter.
g350146
1. Wheel weight adapter
2. Hub drive stud end – 1/2–20 threads
B. Install the wheel weight adapters with studs and tighten them evenly in a
crossing pattern from 95 to 122 N·m (70 to 90 ft–lb).
IMPORTANT
5–76).
Figure 90
3. Wheel weight stud end – 1/2–13 threads
Page 7–4
Removing the Front
Sand Pro ® 3040 and 5040
20251SL Rev A