Toro Sand Pro 3040 Service Manual page 139

Removing and Installing the Hydraulic Fluid Cooler (continued)
Sand Pro ® 3040 and 5040
20251SL Rev A
4. Remove the fasteners at the bottom of the dash shroud and remove the
dash shroud from the machine.
5. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
6. Clean the hydraulic hose ends and fittings on the fluid cooler before
disconnecting the hoses to prevent contaminating the hydraulic system.
To prevent damage to the hydraulic hoses and tubes, cable ties and
clamps may be used to secure the hoses and tubes to the machine
components. Record the location of all cable ties and clamps that
are removed from the machine so they can be properly replaced.
7. Disconnect hydraulic hoses from the fluid cooler and allow the hoses to drain
into a suitable container.
8. Cap or plug the hydraulic fittings and hoses to prevent contamination from
entering the hydraulic system.
9. Remove the fasteners that secure the fan shroud to the frame and carefully
remove the fan shroud and fluid cooler assembly out the bottom of the
machine.
10. Remove the fasteners and rubber clamps that secure the fluid cooler to the
fan shroud and separate the shroud and cooler if necessary.
11. If hydraulic fittings are to be removed from the fluid cooler, mark the fitting
orientation to allow for correct assembly before removing the fittings.
12. Install the fluid cooler in the reverse order.
13. Check and adjust the hydraulic fluid level in the hydraulic tank; refer to the
traction unit Operator's Manual.
IMPORTANT
Page 5–69
General Precautions for
5–54).
Hydraulic System: Service and Repairs