Hydraulic Tank - Toro Sand Pro 3040 Service Manual

Hydraulic Tank

g349634
1. Cap screw (3 each)
2. Flat washer (3 each)
3. Clamp
4. Clamp (2 each)
5. Lock nut (3 each)
6. Plug w/O-ring
7. Plug w/O-ring
8. Grommet
9. Barb fitting
10. Hose – vent
Removing the Hydraulic Tank
Hydraulic System: Service and Repairs
11. Cap
12. Dipstick
13. Hydraulic tank
14. Elbow fitting (2 each)
15. Hose clamp (4 each)
16. Hose – suction
17. Filter head
18. Filter element
19. Hose – suction
20. Tee fitting
Refer to Figure 49 for this procedure.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Remove the center shroud from the machine.
3. Place a drain pan under the hydraulic fluid filter. Make sure that drain pan is
large enough to hold 19 L (5 gal).
4. Remove the hydraulic fluid filter element and allow the hydraulic tank to drain.
Figure 49
21.
22.
23.
24.
25.
26.
27.
28.
FF
Page 5–66
Check valve
Filter bracket
Cap screw (2 each)
Barb fitting
Barb fitting
Hose clamp (2 each)
Hose – case drain
Elbow fitting
position and remove the key
Sand Pro ® 3040 and 5040
20251SL Rev A