Steering Control Valve (Model 08745) - Toro Sand Pro 3040 Service Manual

Steering Control Valve (Model 08745)

g351051
1. Steering control valve
2. Cap screw (4 each)
3. Lock nut (4 each)
Removing the Steering Control Valve
Installing the Steering Control Valve
Sand Pro ® 3040 and 5040
20251SL Rev A
4. Hydraulic tube
5. Hydraulic hose
6. Hydraulic hose
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Remove the fuel tank from the machine; refer to
the Fuel Tank (page
3. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
4. Clean the hydraulic tube ends, and fittings on the steering control valve to
prevent contaminants from entering into the hydraulic system.
5. Label and remove the hydraulic hoses and tubes from the fittings on the
control valve. Allow the hydraulic lines to drain into a suitable container.
6. Install clean caps and plugs on the hydraulic tubes and fittings to prevent
system contamination.
7. Remove the steering wheel from the machine; refer to
Installing the Steering Wheel (page
8. Support the steering control valve and remove the fasteners that secure the
steering control valve to the machine.
1. Slide the steering control valve onto the valve support and secure the
steering control valve to the machine with the previously removed fasteners.
2. Remove the caps and plugs then connect the hydraulic lines to the control
valve fittings; refer to
Seal Fitting) (page
Figure 64
4–12).
7–13).
Installing Hydraulic Hoses and Tubes (O-Ring Face
5–7).
Page 5–99
7. Hydraulic hose
8. Hydraulic tube
position and remove the key
FF
Removing and Installing
General Precautions for
Removing and
Hydraulic System: Service and Repairs
5–54).