Toro Sand Pro 3040 Service Manual page 33

Sand Pro ® 3040 and 5040
20251SL Rev A
High Flow Hydraulic Filter Kit
K–Line Part Number: TOR6011
The high flow hydraulic filter kit is designed with
large flow (150 L/minute or 40 gallons/minute)
and high pressure (34,500 kPa or 5,000 psi)
capabilities. This kit provides for bi-directional
filtration which prevents filtered unwanted material
from entering into the circuit regardless of the flow
direction.
If a component failure occurs in the closed loop
traction circuit, contamination from the damaged
part will remain in the circuit until you remove it.
Install a high flow hydraulic-fluid filter into the circuit
when you connect the hydraulic test gauges in
order to test the traction circuit components or after
you replace a failed traction circuit component
(e.g., piston pump or wheel motor). This filter
removes contamination from the hydraulic fluid in
the traction circuit, thereby preventing additional
component damage.
Note: This kit does not include the hydraulic hoses;
refer to Hydraulic Hose Kit (page
Note: The replacement filter element is Toro
Part No. TOR6012. The filter element canister
tightening torque is 34 N∙m (25 ft-lb).
Multimeter
Obtain this tool locally
The meter can test the electrical
components and circuits for current,
resistance, or voltage.
Note: Use a digital multimeter when
testing the electrical circuits. The high
impedance (internal resistance) of a digital
meter in the voltage mode ensures that
the excess current is not allowed through
the meter. This excess current can
damage the circuits that are not designed
to carry it.
Battery Terminal Protector
Toro Part No. 107-0392
Use this aerosol spray on the battery
terminals, ring terminals, and fork terminals
to reduce corrosion problems. Apply the
terminal protector to the connection after
you secure the battery cable, ring terminal,
or fork terminal.
2–15).
Page 2–17 Specifications and Maintenance: Special Tools