Installing the Lift Control Valves (continued)
Sand Pro
®
3040 and 5040
20251SL Rev A
5. Install the lift lever pivot (item 7) to the lift control valve and the pivot bracket
with the previously removed fasteners.
6. Install the lever guide plate with the previously removed fasteners.
7. Install the right side wheel shroud.
8. Install the console to the machine; refer to
Note: Do not secure the dash assembly to the console until lift lever float
position has been checked.
9. Charge the hydraulic system; refer to
Console (page
7–24).
10. Check the float position of the lift lever and adjust the lever guide plate if
necessary; refer to the traction unit Operator's Manual.
Operator's Console (page
Removing and Installing the Operator's
Page 5–91
Hydraulic System: Service and Repairs
7–24).