Toro Sand Pro 3040 Service Manual page 249

Removing and Installing the Hitch Assembly (continued)
Sand Pro ® 3040 and 5040
20251SL Rev A
3. Remove the rear cover and manual tube assembly.
4. Remove the hitch adapter from the machine:
A. Support the hitch adapter to prevent it from falling during removal.
B. Remove the 2 lower hitch adapter pivot pins.
C. Remove and discard the cotter pin from the clevis pin at the top of the
hitch adapter.
D. Remove the clevis pin, hitch adapter, and roller tube from the machine.
E. Inspect the roller tube bushings for wear or damage and replace if
necessary.
5. If the hitch is being removed from the machine:
A. Remove the lift cylinder pivot pin.
B. Remove the hitch pivot hubs.
C. Remove the hitch from the machine.
6. Remove any remaining hitch assembly components from machine as needed.
7. Inspect the hitch flange bushings for wear or damage and replace if
necessary.
8. Install all previously removed hitch assembly components. Use a new cotter
pin when installing the hitch adapter.
9. Lubricate the hitch assembly grease fittings with Mobilgrease XHP high
temperature grease (or equivalent).
10. Install any previously removed attachments and test the hitch operation
before returning the machine to service.
Page 7–23 Chassis: Service and Repairs