Toro Sand Pro 3040 Service Manual page 34

Specifications and Maintenance: Special Tools
Dielectric Gel
Toro Part No. 107-0342
Use the dielectric gel to prevent
corrosion of unsealed connection
terminals. To ensure that the
terminals are completely coated,
liberally apply the gel to the
component and wire harness
connector, plug the connector
into the component, unplug the
connector, apply the gel to both
surfaces again, and connect
the harness connector to the
component again. The connectors
must be fully packed with gel for
effective results.
Note: Do not use the dielectric gel
on the sealed connection terminals
as the gel can unseat the connector
seals during assembly.
Wheel Hub Puller
K–Line Part Number: TOR4097
The wheel hub puller allows safe
removal of the wheel hub from the
shaft of wheel motors.
Page 2–18 Sand Pro ® 3040 and 5040
20251SL Rev A