Lift Control Valve - Toro Sand Pro 3040 Service Manual

Lift Control Valve

Removing the Lift Control Valves
Sand Pro ® 3040 and 5040
20251SL Rev A
g352024
1. Cap screw (2 each)
2. Flat washer (2 each)
3. Lever guide plate
4. Roll pin
5. Lift lever
6. Curved washer
7. Lift lever pivot
8. Offset link
9. Lock nut (2 each)
The following procedures apply to the standard rear lift valve and the optional
front lift valve (kit model no 08712).
Refer to Figure 59 for this procedure.
1. Park the machine on a level surface, lower any attachments, set the key
switch to the O position and remove the key from the switch.
FF
2. Remove the console from the machine; refer to
the Operator's Console (page
3. Remove the right side wheel shroud.
4. Remove the fasteners securing the lever guide plate to the frame and remove
the guide plate from the machine.
Figure 59
(standard rear lift valve shown)
10. Cap screw (2 each)
11. Lock nut (3 each)
12. Right side wheel shroud
13. Lift control valve
14. Cap screw (4 each)
15. Cap screw (3 each)
16. Pivot bracket
17. Cotter pin
7–24).
Page 5–89
Removing and Installing
Hydraulic System: Service and Repairs