Toro Sand Pro 3040 Service Manual page 186

Removing the Optional Rear Remote Hydraulics Manifold
Hydraulic System: Service and Repairs
Refer to Figure 73 for this procedure.
1. If the hydraulic fittings were removed from the manifold, lubricate new O-rings
with clean hydraulic fluid, position the O-rings to the fittings, and install the
fittings in the marked orientation; refer to
(SAE Straight Thread O-Ring Fittings) (page
2. Secure the rear remote hydraulics manifold assembly and the traction relief
manifold to the bracket with the previously removed fasteners.
3. Remove the caps and plugs then connect the hydraulic tubes to the manifold
fittings; refer to Installing Hydraulic Hoses and Tubes (O-Ring Face Seal
Fitting) (page 5–7).
4. Connect the wire harness to the rear remote hydraulics solenoid valve.
5. Charge the hydraulic system; refer to
5–64).
6. Install the left side screen panel and the left side wheel shroud.
7. Install the rear wheel; refer to
(page 7–5).
Installing the Hydraulic Fittings
Charging the Hydraulic System (page
Removing and Installing the Rear Wheels
Page 5–116
5–9).
Sand Pro ® 3040 and 5040
20251SL Rev A