Installing Traction Pedal and Control Components (continued)
Chassis: Service and Repairs
4. If the rod end was removed from the traction rod, install the rod end so that the
distance from the center of one rod end to the other is 35.8 cm (14.11 inch).
5. Inspect the rubber bushings in the traction rod for wear or damage and
replace if necessary.
6. Use a new cotter pin and to the install the traction rod assembly to the
traction pedal and the pump input cam.
7. After assembly, adjust the traction control assembly for the N
(the machine must not creep in either direction on level ground when the
traction pedal is in the N
System for Neutral (page
8. Ensure the traction neutral switch is connected to the machine wire harness.
9. Install the center shroud.
position); refer to
EUTRAL
5–52).
Page 7–12
position
EUTRAL
Adjusting the Traction
Sand Pro
®
3040 and 5040
20251SL Rev A