Toro Sand Pro 3040 Service Manual page 117

Test Procedure (continued)
Sand Pro ® 3040 and 5040
20251SL Rev A
g355401
1. Elbow fitting at lift cylinder rod end –
capped
4. Cap the disconnected fitting and plug the disconnected hose.
5. Remove the block or jack stand supporting the attachment, then lower and
remove the jack.
6. Sit in the operator's seat hold the lift lever in the L
7. The capped lift cylinder should be able to support the attachment for a short
period (long enough for the machine to move from one area of the work site
to another during operation).
8. Release the lift lever.
9. If the lift cylinder allows the attachment to lower too quickly, replace or repair
the lift cylinder; refer to
Lift Cylinder (page
Servicing the Front Lift Cylinder (Optional) (page
10. After testing:
A. Use a jack to raise the attachment slightly. Support the attachment with
blocks or jack stands to prevent it from lowering. This removes the load
from the lift cylinder and relieves the lift cylinder hydraulic pressure.
B. Remove the cap and plug and connect the hydraulic hose.
C. Check and adjust the level of the hydraulic fluid in the hydraulic reservoir;
refer to the traction unit Operator's Manual.
D. Start the engine and operate the lift cylinder. Check for any hydraulic fluid
leaks. Repair hydraulic leaks if necessary before returning the machine
to service.
Figure 43
2. Hydraulic hose – plugged
Rear Lift Cylinder (page
5–96), Front Lift Cylinder (Optional) (page
Page 5–47 Hydraulic System: Testing the Hydraulic System
position.
OWER
5–94), Servicing the Rear
5–107), or
5–109).