Rear Remote Hydraulics Manifold (Optional) - Toro Sand Pro 3040 Service Manual

Rear Remote Hydraulics Manifold (Optional)

Removing the Optional Rear Remote Hydraulics Manifold
Sand Pro ® 3040 and 5040
20251SL Rev A
g352948
1. Rear remote hydraulics manifold assembly 3.
2. Hydraulic tube (3 each)
The rear remote hydraulics manifold is located near the left rear wheel.
For cartridge valve service procedures, refer to
Valve (page 5–87).
Refer to Figure 73 for this procedure.
1. Remove the left rear wheel; refer to
Wheels (page 7–5).
2. Remove the left side wheel shroud and the left side screen panel.
3. Disconnect the wire harness from the rear remote hydraulics solenoid valve
4. Read and adhere to the information provided in
Removing and Installing the Hydraulic System Components (page
5. Clean the fitting and hydraulic tube connections before disconnecting the
hydraulic tubes to prevent system contamination.
6. Label all hydraulic connections for assembly purposes and disconnect the
hydraulic tubes.
7. Cap the fittings and plug the hydraulic tubes to prevent system contamination.
8. Remove the fasteners securing the traction relief manifold and the rear
remote hydraulics manifold to the bracket and remove the rear remote
hydraulics manifold assembly from the machine.
9. If the hydraulic fittings are to be removed from the manifold, mark the fitting
orientation for assembly purposes and remove the fittings from the manifold.
Discard the O-rings from the fittings.
Figure 73
(view from under machine)
Traction relief manifold assembly
Removing and Installing the Rear
Page 5–115
Servicing a Hydraulic Cartridge
General Precautions for
Hydraulic System: Service and Repairs
5–54).