Toro Sand Pro 3040 Service Manual page 130

Filtering the Closed-loop Traction Circuit (continued)
Hydraulic System: Service and Repairs
g349443
1. Traction (piston) Pump
2. Hydraulic hose
C. If rear wheel motor was replaced, remove the wheel at the new wheel
motor; refer to Removing and Installing the Rear Wheels (page
D. Thoroughly clean the junction of the wheel motor fitting and the hydraulic
tube as shown in
Figure 47
3. Hydraulic tube
Figure 48, then disconnect the tube from the fitting.
Page 5–60
7–5).
Sand Pro ® 3040 and 5040
20251SL Rev A