Toro Sand Pro 3040 Service Manual page 221

Removing and Installing the Battery
Sand Pro ® 3040 and 5040
20251SL Rev A
g353094
1. Positive (+) cable
2. Hex nut (2 each)
3. Negative (-) cable
4. Hold-down rod
5. Battery
Be careful when removing the battery cables and ensure that you do
not damage the terminal posts or cable connectors.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Locate battery at rear of machine and disconnect the negative (-) cable from
the battery terminal, then disconnect the positive (+) cable from the battery
terminal.
3. Remove the fasteners and hold-down rod that secure the to the battery tray.
4. Make sure that the battery filler caps are secure (if applicable) and remove
the battery from the battery tray.
5. Clean the battery tray. Neutralize and refinish any damaged areas of the
battery tray.
6. Inspect the battery cables and connectors for damage and corrosion. Clean,
repair, or replace the battery cables and connectors if necessary.
7. Install the battery in the reverse order:
Figure 88
6. Hold-down post (2 each)
7. Battery tray
8. Wire harness ground connection
9. Cap screw (2 each)
IMPORTANT
FF
Page 6–31
position and remove the key
Electrical System: Service and Repairs