Toro Sand Pro 3040 Service Manual page 231

Installing the Front Wheel (continued)
Removing and Installing the Rear Wheels
Sand Pro ® 3040 and 5040
20251SL Rev A
C. Carefully slide the wheel weight onto the studs and secure the weight to
the wheel with the 2 thrust washers and lock nuts previously removed.
4. Assemble the flangettes and bearing then slide the bearing assembly onto
the spindle shaft so the bearing locking collar faces the wheel.
5. Align the wheel and motor assembly and beating assembly with the fork and
carefully lower the machine. Make sure the bearing assembly and wheel
motor fit snugly against the fork.
6. Secure the wheel motor to the outside of the fork with the previously removed
fasteners. Tighten the fasteners finger tight.
7. Secure the bearing assembly to the outside of the fork with the bearing tab
and previously removed fasteners. Tighten the fasteners finger tight.
8. Remove the jack stands and lower the machine to the ground.
9. Make sure fearing assembly and hydraulic motor are positioned correctly in
the fork and tighten the bearing and motor fasteners.
10. Apply medium strength thread locking compound to the bearing locking collar
set screw and tighten from 10.2 to 13.6 N·m (90 to 120 in–lb).
11. Use the previously removed fasteners to secure the hydraulic tube clamp
to the front fork.
12. Check and adjust the tire pressure; refer to
2–4).
g350167
1. Hub
2. Wheel and tire
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
Figure 91
3. Lug nut (4 each)
FF
Page 7–5
Chassis Specifications (page
position and remove the key
Chassis: Service and Repairs