Toro Sand Pro 3040 Service Manual page 98

Test Procedure
Hydraulic System: Testing the Hydraulic System
excessive heat, cause damage to seals and other components in the hydraulic
system, and affect overall machine performance.
Special Equipment Required:
•
Pressure Gauge (accurate below 300 psi)
•
Flow meter with pressure gauge that has at least a 57 liters/minute (15
gallons/minute) capacity
•
Hydraulic test hose
•
Non-contact tachometer (phototach)
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, and set the key switch to the O
2. Read and adhere to the information provided in
(page 5–23).
3. Ensure that the traction pedal is correctly adjusted for the N
refer to Adjusting the Traction System for Neutral (page
4. Remove the center shroud.
5. Remove the 3 screws that secure the dash panel to the machine, then
carefully raise the dash panel to access the rear fuel tank clamps. Remove
the rear fuel tank clamps.
g354938
1. Center shroud
2. Dash shroud
6. Remove the fasteners at the bottom of the dash shroud and remove the
dash shroud from the machine.
7. Clean the fittings and the hydraulic above the front wheel and on the left side
of the hydraulic fluid cooler; refer to
Figure 31
3. Rear fuel tank clamp (2 each)
4. Dash panel
Figure
Page 5–28
position.
FF
Testing the Hydraulic System
EUTRAL
5–52).
32.
Sand Pro ® 3040 and 5040
20251SL Rev A
position;