Light Switch (Optional) - Toro Sand Pro 3040 Service Manual

Light Switch (Optional)

Testing the Light Switch
Sand Pro ® 3040 and 5040
20251SL Rev A
POSITION CLOSED
CIRCUITS
2 + 1, 5 + 4
OFF
ON 2 + 3, 5 + 6
The light switch is located on the dash panel near the steering wheel.
1. Park the machine on a level surface, lower any attachments, engage the
parking brake, set the key switch to the O
from the switch.
2. Disconnect the battery negative (-) cable at the battery; refer to
and Installing the Battery (page
3. Remove the fasteners securing the dash panel to the operators console and
raise the dash panel.
4. Disconnect the wire harness connector from the switch and remove the
switch from the dash panel if necessary. Check the switch and the harness
connector for damage or corrosion and clean or repair if necessary.
5. Use a multimeter (ohms setting) and the preceding table to determine
whether continuity exists between the various terminals for each switch
position.
6. Replace the switch if necessary.
7. If the switch tests correctly and a circuit problem still exists, check the wire
harnesses; refer to
8. Install the switch and connect the wire harness after testing.
9. Install the dash panel.
10. Connect the battery negative (-) cable at the battery.
FF
6–31).
Appendix A (page A–1).
Page 6–27 Electrical System: Testing the Electrical Components
position and remove the key
Removing