Adjusting the Traction System for Neutral (continued)
Sand Pro
®
3040 and 5040
20251SL Rev A
B. Turn the adjustment cam slowly in the opposite direction until the wheel
begins to rotate in the reverse direction (position R).
C. Turn the adjustment cam to the mid point between position F and R. The
wheels should not rotate in either direction.
7. Tighten the locknut securing the adjustment cam.
8. Shut off the engine.
9. Check the transmission neutral switch air gap and adjust if necessary; refer
to
Adjusting the Traction Neutral Switch (page
10. Install the center shroud.
11. Remove the jack stands and lower the machine to the ground.
12. Test the traction system operation before returning the machine to service.
Page 5–53
6–16).
Hydraulic System: Adjustments