Toro Sand Pro 3040 Service Manual page 246

Removing the Front Fork (Model 08745)
g354776
1. Cap screw
2. Steering pivot
3. Front fork
4. Flat washer (4 each)
5. Cap screw (4 each)
Chassis: Service and Repairs
(model 08745)
6. Steering sleeve
7. Bearing cone (2 each)
8. Bearing cup (2 each)
9. Cap screw (2 each)
10. Hose guide
1. Remove the fuel tank; refer to
4–12).
2. Remove the front wheel; refer to
3. Remove the hose guide from the front fork. Carefully position the hydraulic
hoses away from the fork.
4. Remove the 2 jam nuts securing the steering cylinder ball joint to the front
fork. Use a suitable tool (pickle fork) to separate the ball joint from the front
fork.
5. Support the front fork to prevent it from falling.
6. Remove the 4 cap screws that secure the front fork to the steering pivot and
remove the fork from the machine.
7. If necessary, remove the steering pivot components from the machine:
A. Remove the lock nut and cap screw that retains the steering pivot and
slide the steering pivot from the machine.
Figure 99
11.
12.
13.
14.
15.
Removing and Installing the Fuel Tank (page
Removing the Front Wheel (page
Page 7–20
Set screw
Lock nut
Steering nut
Jam nut (2 each)
Steering cylinder ball joint
7–3).
Sand Pro ® 3040 and 5040
20251SL Rev A