Front Wheel Motor Tests (continued)
g344970
Hydraulic System: Testing
8. Sit in the operators seat, release the parking brake, and set the
Mow/Transport slide to the transport position.
9. Slowly depress forward traction pedal until 68.9 to 103.4 Bar (1000 to 1500
PSI) is displayed on the pressure gauge.
Flow meter should read less than 5.7 LPM (1.5 GPM).
10. Release traction pedal, shut engine off, and record test results.
11. Rotate each front wheel 120 degrees and retest. Repeat this procedure until
each wheel motor has been tested in three (3) different positions.
Proceed to testing rear wheel motor If test results are within specification. If
specifications are not met, test front wheel motors individually as follows:
Model 03171 (shown)
12. Disconnect the hydraulic lines from front wheel motor that is not being tested.
Cap disconnected hydraulic lines and plug ports in wheel motor to prevent
contamination.
13. Chock the front wheel being tested to prevent the wheel rotation.
14. Start the engine. Move throttle to full speed.
Use extreme caution when performing wheel motor tests. The wheel
motors will be trying to move the machine forward.
15. Sit in the operators seat, release the parking brake, and set the
Mow/Transport slide to the transport position.
Figure 41
CAUTION
Page 5–34
Reelmaster
®
3100-D/3105-D
20252SL Rev A