Toro Reelmaster 3100-D Service Manual page 302

Removing the Front Lift Arms
Installing the Front Lift Arms
Wheels, Brakes and Chassis: Service and Repairs
1. Park the machine on a level surface, lower cutting units, stop engine, engage
parking brake and remove key from the key switch.
2. Remove the cutting units from the pivot shaft of the front lift arms (see Cutting
Unit Operator s Manual).
Note: Remove both spacers from the hydraulic cylinder shaft clevis when
removing the right, front lift arm.
3. Disconnect the hydraulic cylinder from the front lift arms by removing external
retaining rings and pins.
4. Remove both flange head screws and pivot shaft link from the lift arm pivot
shafts.
5. Slide the lift arm off the pivot shaft.
6. Disassemble lift arm as necessary using
7. Inspect bushings in lift arm and carrier frame. If bushings are worn or
damaged, replace bushings.
1. Assemble the lift arm using
2. Slide the lift arm onto the lift arm pivot shaft.
3. Secure the pivot shaft link with both flange head screws to the lift arm pivot
shafts.
Note: Install both spacers to the hydraulic cylinder shaft clevis when
installing the right, front lift arm.
4. Secure the hydraulic cylinder to the lift arm with pins and external retaining
rings.
5. Adjust lift arms (see Traction Unit Operator
6. Install cutting unit to the front lift arm pivot shaft (see Cutting Unit Operator
Manual).
7. Grease front lift arms (see Traction Unit Operator
Figure 160
Figure 160 as a guide.
Page 7–24
as a guide.
s Manual).
s Manual).
Reelmaster ® 3100-D/3105-D
20252SL Rev A
s