Toro Reelmaster 3100-D Service Manual page 282

Adjusting the Brake (continued)
Wheels, Brakes and Chassis: Adjustments
Before jacking up the machine, review and follow
Instructions (page
B. Chock rear wheel. Jack up both front wheels and support the machine
with hardwood blocks.
C. With the parking brake applied, use a torque wrench on the wheel hub
lock nut to identify the break away torque at each front wheel. The
minimum break away torque with the parking applied should be 366 N·m
(270 ft−lb).
g344081
1. Clevis
2. Adjustment rod
3. Brake lever
4. If adjustment is necessary, adjust brakes as follows:
A. Remove both front wheel assemblies from the machine (see
the Front Wheel and Brake (page
B. Adjust brakes by turning clevis to increase or decrease shoe pressure on
the brake drum
against drums with the parking brake lever released.
C. If brakes can not be adjusted properly, repair or replace brake
components as necessary.
D. After adjustment is complete, install front wheel assemblies to the
machine (see Installing the Front Wheel and Brake (page
E. Lower front wheels to the ground.
F. Before starting engine, close by-pass valve on pump by rotating it 90
degrees (Figure
CAUTION
1–7).
Figure 148
4. Wheel hub
5. Cotter pin
6. Jam nut
7–9)).
(Figure 148). Make sure that the brake shoes do not drag
147).
Page 7–4
Jacking
Removing
7–11)).
Reelmaster ® 3100-D/3105-D
20252SL Rev A