Toro Reelmaster 3100-D Service Manual page 210

Removing the Steering Control Valve
Installing the Steering Control Valve
Hydraulic System: Service and Repairs
1. Park the machine on a level surface. Lower cutting units, stop engine and
engage parking brake. Remove key from the key switch.
2. Thoroughly clean the hydraulic hose ends and fittings on steering control
valve to prevent hydraulic system contamination.
Before disconnecting or performing any work on the hydraulic
system, all pressure in the system must be relieved. See
Hydraulic System Pressure (page
g345940
1. Tilt bracket
2. Jam nut
3. Flat washer
3. Label all hydraulic hoses and fittings for assembly purposes. Note port
identification on steering control valve.
4. Remove the steering control valve from the steering column using the
101 and Figure 102.
1. Install the steering control valve to the steering column using the
101 and Figure 102.
2. Use labels placed during the removal process to properly install hydraulic
hoses to control valve.
3. Adjust location of steering shield so that it just contacts hydraulic hoses when
the steering wheel is tilted to its lowest position.
4. Make sure hydraulic tank is full. Add correct fluid if necessary.
WARNING
5–3).
Figure 102
4. Friction disc
5. Steering tilt lever
Page 5–134
Relieving
Figure
Figure
Reelmaster ® 3100-D/3105-D
20252SL Rev A