Assembly of Height Adjuster Assembly
Reelmaster
®
3100-D/3105-D
20252SL Rev A
1. Apply anti-seize lubricant to upper threads of adjustment rod and lower
threads of height adjusters. Assemble height adjuster assembly as shown.
2. If both height adjusters were removed, fit one height adjuster assembly to
the cutting unit side plate and secure with carriage bolt and flange nut. Do
Not tighten the flange nut at this time. Ensure the height adjustment bolt
and one (1) washer is above slot in side plate and one (1) washer and lock
nut is below slot in side plate.
3. Position front roller between height adjuster assemblies and secure height
adjuster assembly to cutting unit side plate with carriage bolt and flange nut.
Do Not tighten the flange nut at this time. Ensure the height adjustment
bolt and one (1) washer is above slot in side plate and one (1) washer and
lock nut is below slot in side plate.
4. Use new cotter pins and install the cotter pins and clevis pins securing the
height adjustment rods to the groomer gear box and idler arm.
5. Adjust the cutting unit height of cut: refer to Cutting Unit Operators Manual.
6. Check groomer reel height and adjust as needed.
Page 9–21
Universal Groomer (Optional): Service and Repairs