Toro Reelmaster 3100-D Service Manual page 202

Removing the Control Valve (continued)
Installing the Control Valve
Hydraulic System: Service and Repairs
g345780
1. Spool valve
2. Magnet support bracket
Before disconnecting or performing any work on the hydraulic
system, all pressure in the system must be relieved. See
Hydraulic System Pressure (page
2. Remove the control valve from the frame using
guides.
3. If hydraulic fittings are to be removed from control valve, mark fitting
orientation to allow correct assembly.
1. If fittings were removed, install fittings to control valve using marks made
during the removal process to properly orientate fittings.
2. Install the control valve to the frame using
3. Make sure hydraulic tank is full. Add correct fluid if necessary (see
Operator 's Manual).
Figure 97
3. Flange head screws
4. Frame
WARNING
5–3).
Figure 96
Page 5–126
Relieving
Figure 96 and Figure 97
and Figure 97 as guides.
Reelmaster ® 3100-D/3105-D
20252SL Rev A
as