Installing the Rear Lift Arm (continued)
Reelmaster
®
3100-D/3105-D
20252SL Rev A
4. Install the rear cutting unit to the pivot shaft of the rear lift arm (see Cutting
Unit Operator
s Manual).
5. Adjust the lift arm (see Traction Unit Operator
Make sure hydraulic hoses are free of twists and sharp bends. Raise
cutting units and make sure that rear cutting unit hoses do not con-
tact the traction cable bracket. If required, reposition fittings and
hoses.
6. Grease the rear lift arm (see Traction Unit Operator
IMPORTANT
Page 7–27
Wheels, Brakes and Chassis: Service and Repairs
s Manual).
s Manual).