Height Adjuster Assembly
g343767
1.
Height of cut bracket
2.
Height adjustment bolt
3.
Washer (2)
4.
Lock nut
5.
Carriage bolt
6.
Flange nut
7.
Cotter pin
Disassembly of Height Adjuster Assembly
Universal Groomer (Optional): Service and Repairs
8.
Clevis pin
9.
Button head screw
10.
Detent spring
11.
Groomer height adjuster knob
12.
Quick up cover
13.
Quick up lever
14.
Pinch bolt (front roller)
1. Park machine on a clean and level surface, lower cutting units completely
to the ground, stop engine, engage parking brake and remove key from the
key switch.
2. Remove the cotter pins and clevis pins securing the height adjustment rods
to the groomer gear box and idler arm. Discard cotter pins.
3. Loosen the two (item 2 in
4. Loosen the two (2) front roller pinch bolt lock nuts and cap screws.
5. Remove the flange nut and carriage bolt securing the height adjuster
assembly to the cutting unit side plate and remove the front roller and height
adjuster from the cutting unit.
6. Disassemble height adjuster assembly; refer to
7. Clean all components and inspect for wear or damage. Replace all worn or
damaged components.
Figure 218
15.
16.
17.
18.
19.
Figure
218) height adjustment bolt lock nuts.
Page 9–20
Lock nut
Washer (2)
Outer spring
Inner spring
Height adjustment rod
Figure
218.
Reelmaster
®
3100-D/3105-D
20252SL Rev A