Toro Reelmaster 3100-D Service Manual page 340

Installing the Front Roller (continued)
DPA Cutting Units: Service and Repairs
B. Apply anti-seize lubricant to cap screw threads that will extend into
height-of-cut (roller) bracket.
C. Thread cap screw into bracket.
Note: When assembling height-of-cut (roller) brackets to side plate, make
sure that the cap screw head and one washer are above adjustment flange
on side plate and second washer and flange lock nut are below flange.
3. If both front height-of-cut (roller) brackets were removed from cutting unit side
plate, position one of the brackets to side plate. Secure bracket to side plate
with carriage screw and flange lock nut.
4. Slide front roller shaft into bracket attached to the cutting unit. Slide second
height-of-cut (roller) bracket onto the other end of roller shaft. Secure second
bracket to cutting unit side plate with carriage screw and flange nut.
5. Apply Loctite #243 (or equivalent) to exposed threads of cap screw (item 1)
between flange of side plate and position of flange lock nut (item 3) on cap
screw. Tighten flange lock nut on cap screw and then loosen nut 1/4 to 1/2
turn. Cap screw should rotate freely with little (if any) endplay after lock
nut installation.
6. Apply Loctite #243 (or equivalent) to threads of two (2) cap screws (item
6). Center front roller to the cutting reel and secure in place with two (2)
cap screws. Torque cap screws from 20 to 26 N·m (15 to 19 ft-lb). Secure
cap screws with flange nuts.
7. Lubricate the front roller.
8. Adjust the cutting unit; refer to Cutting Unit Operator's Manual.
Page 8–32 Reelmaster ® 3100-D/3105-D
20252SL Rev A