Toro Reelmaster 3100-D Service Manual page 37

Reelmaster ® 3100-D/3105-D
20252SL Rev A
Multimeter
Obtain this tool locally
The meter can test the electrical
components and circuits for current,
resistance, or voltage.
Note: Use a digital multimeter when
testing the electrical circuits. The high
impedance (internal resistance) of a digital
meter in the voltage mode ensures that
the excess current is not allowed through
the meter. This excess current can
damage the circuits that are not designed
to carry it.
Battery Terminal Protector
Toro Part No. 107-0392
Use this aerosol spray on the battery
terminals, ring terminals, and fork terminals
to reduce corrosion problems. Apply the
terminal protector to the connection after
you secure the battery cable, ring terminal,
or fork terminal.
Battery Hydrometer
Use the battery hydrometer when
measuring the specific gravity of the
battery electrolyte. You can get this tool
locally.
Dielectric Gel
Toro Part No. 107-0342
Use the dielectric gel to prevent corrosion
of unsealed connection terminals. To
ensure complete coating of the terminals,
liberally apply the gel to the component
and wire harness connector, plug the
connector into the component, unplug the
connector, apply the gel to both surfaces
again, and connect the harness connector
to the component again. The connectors
must be fully packed with gel for effective
results.
Note: Do not use the dielectric gel on
the sealed connection terminals as the
gel can unseat the connector seals during
assembly.
Page 2–17 Specifications and Maintenance: Special Tools