Installing the Reel Motors (continued)
Reelmaster
®
3100-D/3105-D
20252SL Rev A
5. Rotate the motor counter-clockwise until the motor flanges are encircling
the cap screws. Tighten two (2) cap screws to secure reel motor to cutting
unit
(Figure
83).
6. Remove the caps or plugs from fittings and hoses.
When installing the hydraulic hoses, make sure that the hydraulic
hoses are straight (not twisted) before tightening the hoses to the
motor fittings.
7. Lubricate and install new O−rings on motor fittings. Correctly connect
hydraulic hoses to the motor using labels placed during removal procedure
(Figure
82).
8. Check the fluid level in hydraulic reservoir and add correct fluid if necessary.
IMPORTANT
Page 5–105
Hydraulic System: Service and Repairs