Toro Reelmaster 3100-D Service Manual page 154

Removing the Neutral Arm (continued)
Installing the Neutral Arm
Hydraulic System: Service and Repairs
1. Park machine on a level surface. Lower cutting units, stop engine and
engage parking brake. Remove key from the key switch.
2. Raise and support the hood.
The extension spring is under tension and may cause personal
injury during removal. Use caution when removing spring from the
pump lever.
3. Remove extension spring from the cable support bracket and neutral arm.
4. Disconnect traction control cable from the pump lever. Locate and retrieve
three (3) flat washers and record their position for assembly purposes.
5. Remove both flange head bolts securing the neutral bracket to the piston
pump. Remove flange nut and flange head bolt securing the neutral bracket
to the pump mount plate.
6. Remove cap screw and flat washer that secure the pump lever and hub
assembly to the piston pump trunnion.
7. Separate pump lever and hub assembly from pump trunnion and neutral
bracket from mount plate. Locate and retrieve key from trunnion.
1. Install key into trunnion slot. Position neutral bracket to the mount plate and
the pump lever and hub assembly to the pump trunnion.
2. Secure pump lever and hub assembly to the piston pump trunnion with flat
washer and cap screw.
3. Secure neutral bracket to the pump mount plate with flange head bolt and
flange nut. Secure neutral bracket to the piston pump with both flange head
bolts.
4. Position three (3) flat washers to traction control cable end. Secure traction
control cable to the pump lever with cap screw and lock nut.
The extension spring is under tension and may cause personal
injury during installation. Use caution when installing the spring
to the pump lever.
5. Install extension spring to the cable support bracket and neutral arm.
6. Adjust the traction drive for neutral; refer to Operator's Manual.
7. Lower and secure the hood.
CAUTION
CAUTION
Page 5–78 Reelmaster ® 3100-D/3105-D
20252SL Rev A