Toro Reelmaster 3100-D Service Manual page 351

Disassembling the Drive System
g343595
1. Carriage screw (2 used)
2. Carriage screw (3 used)
3. Brush plate
4. Cap screw (2 used)
5. Flat washer (4 used)
6. Lock nut (6 used)
7. Idler arm
8. Idler spacer
Reelmaster ® 3100-D/3105-D
20252SL Rev A
9. Idler spring
10. Pivot washer
11. Drive belt
12. Idler pulley
13. Retaining ring
14. Bearing
15. Shoulder screw
16. Flange head screw
Note: Drive components for the rear roller brush are located on the opposite side
of the cutting unit from the cutting reel motor.
used when the brush drive is on the left side of the cutting unit.
Note: The Installation Instructions for the rear roller brush kit has detailed
information regarding assembly and adjustment. Use those Instructions along
with this Service Manual when servicing the rear roller brush.
1. Position machine on a clean and level surface, lower cutting units, stop
engine, engage parking brake and remove key from the key switch.
2. Remove cover (item 20) to access rear roller brush drive components.
3. Remove roller brush drive components as necessary using
a guide.
Figure 199
17.
18.
19.
20.
21.
22.
Page 8–43
Drive pulley
Spacer
Flange bushing
Cover
Flange nut (2 used)
Set screw (top of cover only)
Figure 199 shows components
Figure 199
DPA Cutting Units: Service and Repairs
as