Installing the Bedbar Assembly (continued)
DPA Cutting Units: Service and Repairs
7. Install the bedbar pivot bolt assemblies:
A. Push each bedbar pivot bolt through the side plate and into the bedbar
enough to hold the bedbar in position.
Do Not use a powered wrench or an impact wrench to install the
bedbar pivot bolts.
B. Start threading of one of the pivot bolts into the bedbar and continue until
the pivot bolt bottoms out. Repeat for remaining pivot bolt.
C. Make sure that plastic washers are not caught on the threads of the
pivot bolts.
D. Tighten each bedbar pivot bolt from 37 to 44 N·m (27 to 33 ft- lbs).
8. Tighten both lock nuts (item 10 in
rotates. Do not over tighten the lock nuts as this can distort the side plates
and affect reel to bedknife contact, or in the case of cutting units with painted
side plates, reel bearing adjustment. The plastic washer between the bedbar
and side plate should be loose.
9. Tighten the lock nut (item 2) on each bedbar adjuster assembly until the
adjuster spring is fully compressed, then loosen lock nut 1/2 turn.
10. Adjust cutting unit (refer to Cutting Unit Operator's Manual).
11. Install cutting unit to machine.
IMPORTANT
Figure
169) until outside metal washer just
Page 8–12
Reelmaster
®
3100-D/3105-D
20252SL Rev A