Installing the Bedknife (continued)
Grinding the Bedknife
DPA Cutting Units: Service and Repairs
g251663
5. Using a torque wrench and bedknife screw tool, tighten the 2 outer screws to
1 N·m (10 in-lb).
6. Working from the center of the bedknife toward each end (refer to
172), tighten screws from 23 to 28 N·m (200 to 250 in-lb).
7. After installing bedknife to bedbar, grind bedknife.
g207291
1.
Top angle
2.
Top surface
3.
Remove burr (without dulling sharp corner)
Figure 172
Figure 173
4.
Front surface
5.
Front angle
Page 8–14
Figure
Reelmaster
®
3100-D/3105-D
20252SL Rev A