Toro Reelmaster 3100-D Service Manual page 74

Removing the Engine (continued)
Installing the Engine
Engine: Service and Repairs
Make sure not to damage the engine, fuel and hydraulic lines,
electrical harness, or other parts while removing the engine.
14. Remove engine slowly from the machine.
15. Separate hydrostat and pump mount plate from the engine as follows:
Note: The cap screw next to the torsion spring does not have a flat washer
with it.
g342504
1. Cap screw
2. Spacer
A. Remove hydrostat belt from the engine fly wheel and hydrostat pulleys
(see Hydrostat Belt Replacement in Operator's Manual).
B. Remove five cap screws, four washers, and five spacers securing the
pump mount plate to the engine; refer to
C. Remove four cap screws (item 32 in
(10) securing the right engine mounting bracket (33) and hydrostat to
the engine.
1. Install hydrostat and pump mount plate to the engine as follows:
A. Secure right engine mounting bracket (33) and hydrostat to the engine
four hardened washers (10) and cap screws (32).
Note: Do not install flat washer with cap screw near the torsion spring
to prevent the spring from binding.
B. Secure pump mount plate to the engine with five spacers, four washers,
and five cap screws; refer to
C. Install hydrostat belt to the engine fly wheel and hydrostat pulleys (see
Hydrostat Belt Replacement in Operator's Manual).
2. Connect hoist or lift to the front and rear lift tabs.
IMPORTANT
Figure 21
3. Torsion spring
4. Pump mount plate
Figure
Figure 21.
Page 4–18
Figure 21.
16) and hardened washers
Reelmaster ® 3100-D/3105-D
20252SL Rev A