Toro Reelmaster 3100-D Service Manual page 221

Installing the Rear Lift Cylinder
Reelmaster ® 3100-D/3105-D
20252SL Rev A
1. If fittings were removed from lift cylinder, lubricate and place new O−rings
onto fittings. Install fittings into cylinder port openings using marks made
during the removal process to properly orientate fittings. Tighten fittings
(see Installing the Hydraulic Fittings (SAE Straight Thread O-Ring Fittings)
(page 5–8)).
2. Install the rear lift cylinder to the frame and lift arm using
3. Attach hydraulic hoses to lift cylinder (see
Tubes (O-Ring Face Seal Fittings) (page
4. Fill the reservoir with hydraulic fluid as required.
5. Adjust the rear lift arm; refer to Operator's Manual.
6. After installation is completed, operate lift cylinder to verify cylinder, hydraulic
hose and fitting clearance.
Installing Hydraulic Hoses and
5–6)).
Page 5–145
Figure 107 as guide.
Hydraulic System: Service and Repairs