Toro Reelmaster 3100-D Service Manual page 54

Factor
Height-of-cut
Proper bedknife selection for height-of-cut desired
Stability of bedbar
Number of reel blades
Cutting unit alignment and carrier frame ground
following
Roller condition and roller type
Cutting unit accessories
Troubleshooting:
Possible Problem/Correction
"Effective" or actual height-of-cut depends on the cutting unit weight
and turf conditions. Effective height-of-cut will be different from the
bench set height-of-cut.
See Height-of-Cut Adjustment in the Cutting Unit Operator's Manual.
If the bedknife is incorrect for effective height-of-cut, poor quality of
cut will result.
See Cutting Unit Operator's Manual for bedknife options.
Make sure bedbar pivot bolts are seated securely. Check condition of
the bushings in the side plates.
See Bedbar Assembly (page
Use correct number of reel blades for clip frequency and optimum
height-of-cut range.
Refer to Clip Chart in Traction Unit Operator's Manual.
Check carrier frames and lift arms for damage, binding conditions or
bushing wear. Repair if necessary.
Make sure rollers rotate freely. Repair roller bearings as necessary.
See Servicing the Roller (page
Refer to Cutting Unit Operator's Manual for roller options.
A variety of cutting unit accessories are available that can be used to
enhance after-cut appearance. Refer to Operator's Manual for a listing
of available accessories.
Page 3–10
8–10).
8–36).
Reelmaster ®
20252SL Rev A
3100-D/3105-D