Toro Reelmaster 3100-D Service Manual page 332

Installing the Reel Assembly (continued)
DPA Cutting Units: Service and Repairs
13. Adjust the cutting unit (refer to Cutting Unit Operator's Manual).
Note: The parallel position of the rear roller to the cutting reel is controlled by
the precision machined frame and side plates of the cutting unit. If necessary,
the cutting unit side plates can be loosened and a slight adjustment can be
made to parallel the rear roller with the cutting reel (refer to
Roller (page 8–4)).
14. Install accessories if equipped. refer to
(Optional) (page 9–1)
Refer to Rear Roller Brush – Optional (page 8–40)
brush.
g343555
1. Spline insert (LH)
2. Reel shaft
15. Tighten the spline inserts:
A. Insert a long-handled pry bar (3/8 x 12 inch with a screwdriver handle
recommended) through the front of the cutting unit. The pry bar should
pass between the top of the reel shaft and the backs of the reel blades so
that the reel will not move.
To avoid grinding the reel, do not contact the cutting edge of
any blade with the pry bar as this may damage the cutting edge
and/or cause a high blade.
B. Move the pry bar against the weld side of the reel support plate closest to
the spline insert being tightened.
The spline insert on the left end of the cutting reel has left hand
threads and the spline insert on the right end of the cutting reel
has right hand threads.
Chapter 9: Universal Groomer
in this manual for additional Groomer information.
Figure 181
3. Reel support plate
4. Pry bar
IMPORTANT
IMPORTANT
Page 8–24
Leveling Rear
information on rear roller
Reelmaster ® 3100-D/3105-D
20252SL Rev A