Shop Roller Assembly (Model 03192) - Toro Reelmaster 3100-D Service Manual

Shop Roller Assembly (Model 03192)

Removing the Shop Roller Assembly
Installing the Shop Roller Assembly
Reelmaster ® 3100-D/3105-D
20252SL Rev A
g348049
1. Clevis pin
2. Carriage bolt
3. Cotter hairpin
4. Flange head nut
1. Position machine on a clean and level surface, lower cutting units, stop
engine, engage parking brake and remove key from the key switch.
Before the cutting units are lowered to the shop floor or removed
from the traction unit, lower the shop roller assemblies to protect the
reel and bedknife blades from hard surface contact.
2. Remove the cotter hairpin from the clevis pin that secures the shop roller
bracket to the side plate.
3. Remove the shop roller assembly from the cutting unit.
4. Disassemble the shop roller assembly by using the
1. Assemble the shop roller assembly by using the
2. Install the shop roller assembly onto the side plate of the cutting unit.
3. Secure the shop roller assembly with clevis pin and cotter hairpin.
Ensure that the clevis pin is always installed in the top square hole
in the side plate.
4. Adjust the shop roller assembly; refer to Cutting Unit Operator's Manual.
Figure 187
5. Washer
6. Spacer
7. Roller
8. Roller bracket
IMPORTANT
IMPORTANT
Page 8–33
Figure 187 as a guide.
Figure 187 as a guide.
DPA Cutting Units: Service and Repairs