Toro Reelmaster 3100-D Service Manual page 40

Specifications and Maintenance: Special Tools
Handle Assembly
K-Line Part No. 29-9100
Used to apply lapping compound
to cutting units while keeping the
operator's hands at a safe distance
from the rotating reel.
Components for the handle
assembly are available individually
as follows:
• Brush 36-4310
• Handle 29-9080
• Handle cap 2410-18
Plastic Plug
K-Line Part No. 94-2703 (for
7 inch reels)
K-Line Part No. 2410-30 (for
5 inch reels)
This cap is used for placement
into the cutting unit side
plate when the cutting reel
motor is removed. It prevents
dirt and unwanted material
from entering the cutting reel
bearing area.
Cutting Unit Kickstand
Toro Part No. 119-8010-03
The cutting unit kickstand is used
to prop up the rear of the cutting
unit during service. Use of this
tool stabilizes the cutting unit and
prevents the bedbar adjusting
screws from resting on the work
surface.
Spline Insert Tool
K-Line Part No. TOR4112 (8 tooth
for 5 inch reels)
K-Line Part No. TOR4074 (9 tooth
for 7 inch reels)
Use the spline insert tool for
rotating the cutting reel when motor
is removed. Also use this tool for
installation of threaded inserts into
the cutting reel shaft.
Page 2–20 Reelmaster ® 3100-D/3105-D
20252SL Rev A