Reel Circuit Testing − Reel Motor Efficiency/Case Drain Test
(continued)
Reelmaster
®
3100-D/3105-D
20252SL Rev A
14. Hold disconnected motor case drain hose into a container graduated in
ounces or milliliters (e.g. Toro #TOR4077) and collect hydraulic fluid for 30
seconds. After 30 seconds, remove hose end from container.
15. Record the amount of fluid collected in the container.
16. Disengage the cutting units, set the throttle to low speed, and stop engine.
17. If volume is more than 1265 milliliters (43 oz), repair or replace the tested
reel motor.
18. Remove tester and reconnect hydraulic hoses.
19. Check hydraulic fluid level (see Traction Unit Operator's Manual).
20. Repeat test for remaining reel motors as needed.
Page 5–45
Hydraulic System: Testing