Groomer Reel Service - Toro Reelmaster 3100-D Service Manual

Groomer Reel Service

g220506
1. Groomer reel shaft
2. Groomer blade (40 each)
3. 31.7 mm (1–1/4 inch) spacer (39
each)
Disassembling the Groomer Reel
Assembling the Groomer Reel
Reelmaster ® 3100-D/3105-D
20252SL Rev A
4. 6.3 mm (1/4 inch) spacer (2 each)
5. Locknut (2 each)
6. Centered on shaft
Inspect groomer reel blades frequently for damage and wear. Straighten bent
blades. Either replace worn blades or reverse the individual blades to put
the sharpest blade edge forward
the midpoint of the blade tip must be reversed or replaced for best groomer
performance.
1. Park machine on a clean and level surface, lower cutting units completely
to the ground, stop engine, engage parking brake and remove key from the
key switch.
2. Remove groomer reel from cutting unit (refer to
(page 9–15)).
3. If groomer reel is equipped with broomer kit, remove straps and broomer
brushes from reel (Figure
4. Remove lock nut from either end of the shaft
5. Remove spacers and blades from groomer shaft. If needed, remove second
lock nut from shaft.
1. Install lock nut on drive end of groomer shaft. Place a 6.3 mm (1/4 in) spacer
on the groomer shaft followed by the first groomer blade.
2. Alternately install 31.7 mm (1-1/4 in) spacers and blades making sure that all
blades are separated by a spacer.
3. When all blades have been installed, place remaining 6.3 mm (1/4 in) on
shaft. Thread second lock nut onto the shaft. Center blades on shaft by
adjusting lock nuts.
Figure 215
(Figure 215). Blades that are rounded to
216).
Page 9–17 Universal Groomer (Optional): Service and Repairs
7. Sharp edge
8. Midpoint
9. Dull (rounded) edge
Removing the Groomer Reel
(Figure 215).