Turning Power "On" And "Off; Turning Power "On - Sharp AR-FX2 Operation Manual

TURNING POWER "ON" AND "OFF"

To turn the power on and off, use the power switch located on the left side of the cabinet.
Power On
1-4

Turning Power "ON"

To use the fax or copier, turn the power switch located on the left side of the
cabinet to the "ON" position.
1 Turn the power switch to the "ON" position.
After 15 seconds, the system check is finished and the machine enters
the copier or fax mode initial state. To switch between copier and fax
modes press the COPY/FAX key. (See page 1-6)
When using the fax function, when the initial state is
displayed, you can send faxes.
Note
When you turn on the power, the machine enters
copier mode or fax mode depending on the last mode
used before power was turned off. For example, if the
machine is in copier mode and the power is turned
off, it will enter copier mode when the power is turned
on again. Likewise, if the machine is in fax mode and
the power is turned off, it will enter fax mode when
the power is turned on again.
The machine is set up from the factory to enter a
power save mode from the copier or fax modes if it is
turned on and not used for a specified period of time.
For more information, see the "POWER SAVE
MODES" section of the copier operation manual.
Do not switch the machine rapidly on and off. After
turning the power off, wait five seconds or more before
turning it back on.