How To Use Memory Polling - Sharp AR-FX2 Operation Manual

POLLING

How to Use Memory Polling

You can allow others to poll your fax machine and send them an original that has been previously read into memory (memory
polling). If you have originals set for other operations, you can still perform memory polling. The fax machine cannot send the
original if you simply place the original in the SPF or on the original table (it must be read into memory first).
Your fax
machine
Select memory polling
After polling is completed, you can choose to have the original that was scanned into memory is automatically deleted or
preserved. If you preserve the original in memory, another person can poll your fax machine and receive the same original.
Reading an original into memory for memory polling/Adding to an original that has
already been scanned into memory for memory polling
Set the original and adjust the original size, resolution, and exposure if necessary, then perform the following procedure.
3-20
The original is read
into memory
Polling fax
machine
Select polling
In fax mode, press the SENDING OPTIONS key.
1
2 Press the "4" key.
MEMORY POLL MODE
1=SET, 2=CLEAR
Instead of pressing the "4" key you can also press the left arrow key
( ) or right arrow key ( ) until this message appears and press the
ENTER key.
If there is no original currently in memory for memory polling,
proceed to step 4.
Polling is
approved
polling
POLLING
beep
Original is received
Original is sent
from memory