Backing Up And Restoring Settings - Hitachi Compute Blade 2000 User Manual

Backing up and restoring settings

 DC command
This command restores settings to factory defaults. Type DC at the prompt and press
Enter.
5713RF0 NNNNN(0)IOEU>
<< DC - Restore factory setting. >>
-- Restore setting menu --
R. Restore factory setting.
Q. Quit.
(R,[Q]) :
Select a menu item from the following list to execute it.
Menu
R. Restore factory setting.
Q. Quit
If you type R at the DC command menu and press Enter, a warning message appears
indicating that if you proceed to reset the I/O module, the I/O module will restart to
terminate the current session. To restore the I/O module to the defaults and restart,
type Y at the confirmation prompt and press Enter. To cancel the operation, at the
confirmation prompt, type N and then press Enter, or press Enter.
(R,[Q]) : R (Enter)
WARNING : If confirm, this connect is lost.
Confirm? (Y,[N]) : Y
- <I/O module0> Restarting
(Disconnected.)
DC(Enter)
Restores the settings of the I/O module to the factory
defaults.
Quits the DC command.
(Enter)
985
Description