If you enter Z in the LFT command menu and press Enter, the current redundancy
setting in the MGMT0 port of the management LAN port appears. At the prompt, enter
the redundancy setting of the management LAN port, and the current time to ascertain
linkdown is displayed in seconds. At the next prompt, enter a time to ascertain
linkdown in seconds. At the next prompt, enter a setting in seconds to ascertain linkup,
and the changed setting value is displayed. A confirmation message appears. At the
prompt, enter Y and press Enter, and the VLAN setting is saved. To cancel the setting
change, enter N and press Enter, or just press Enter.
(Z,O,[Q]) : Z (Enter)
LFT : Enable
(0=Disable,1=Enable,[Unchange]) : 0 (Enter)
Down(s) : 3
(1-3600,[Unchange]) : 10 (Enter)
Up(s) : 180
(1-3600,[Unchange]) : 1800 (Enter)
-- Link Fault Tolerance setting --
Ext port Management module LFT
-------- ----------------- ------- ------- -----
MGMT-0
Active
MGMT-1
Active
MNT
Active
Confirm? (Y,[N]) : Y (Enter)
- Writing setting was completed.
Hit enter key. (Enter)
If you enter O in the LFT command menu and press Enter, you can change the
redundancy setting in the management LAN port of the MGMT1 port.
For the MAINT port, you can only display the setting.
Down(s) Up(s)
Disable
10
1800
Enable
3
180
Enable
3
180
562