Hitachi Compute Blade 2000 User Manual page 957

Condition Status: failure
status
AC input AC input status
AC input voltage setting is described in the table below.
Description of
Item
Voltage AC input voltage
setting of the
power supply
 IOC command
You can display I/O module status and operate the module. Type IOC at the prompt,
and press Enter.
5713RF0 NNNNN(0)IOEU> IOC
<< IOC – I/O module control. >>
-- I/O module status --
# Behavior Power Condition
- -------- ----- ------------- --------
0 Active On
1 Standby On
-- I/O module control menu --
P. Power control.
L. LID lamp control.
Q. Quit.
(P,L,[Q]) :
Select a menu item from the following list to execute it.
Menu
P. Power control.
L. LID lamp control
Q. Quit
Items of I/O module status are described in the table below.
Description of
Item
-------
Normal
FAIL
-------
Normal
None
Value
item
100
200
Unknown
(Enter)
LID lamp
Normal Off
Normal Off
Executes the power operation of the I/O module.
Executes the identification light-emitting diode (LED) of the
I/O module.
Quits the IOC command.
Value
item
906
No power supply module is
installed.
No problem
The power supply fails.
No power supply module is
installed.
AC input exists.
No AC input.
Description of value
AC input voltage: 100 V (Not
supported)
AC input voltage: 200 V
The setting value is unknown.
Description
Description of value