Hitachi Compute Blade 2000 User Manual page 651

 HCSM command
You can set the HCSM (Hitachi Compute Server Manager). Enter HCSM at the prompt
and press Enter.
5713RF0 NNNNN(0)SVP> HCSM (Enter)
<< HCSM - HCSM setting. >>
-- HCSM service setting --
HCSM : Enable
Access control : Disable
Port number : 443
Account : Compute
-- HCSM server setting --
No. IP address
--- --------------- ---------- ------------- -------- -------- -------------
1 192.168. 0. 20
2 192.168. 0. 51
-- HCSM setting menu --
A. Edit HCSM service.
M. Edit HCSM server.
D. Disconnect session.
S. Send alert.
Q. Quit.
(A,M,D,S[Q]) :
Select a menu item from the following list, and execute it.
Menu
A. Edit HCSM service.
M. Edit HCSM server.
D. Disconnect session.
S. Send alert.
Q. Quit.
HCSM service settings are described in the table below:
Item Description of item
HCSM Enable or Disable
HCSM
Access Access control
control
Port number Port number used by
HTTP/HTTPS server
Account HCSM account
Alert port Alert level
26119 Warning
26119 All
Sets the HCSM service.
Sets the HCSM server.
Disconnects the session.
Sends a test alert.
Quits the HCSM command.
Enable
Disable
Enable
Disable
Integer
A string in
ASCII
600
Retry Retry
interval Duration Session
2 10 Connected
2 10 Not connected
Description
Value Description of value
Enables HCSM.
Disables HCSM.
Responds to a discovery only
from the registered HCSM
server.
Responds to a discovery from
HCSM servers, both registered
and not-registered.
Integer: 1 up to 65535
ASCII characters: 1 up to 32