Hitachi Compute Blade 2000 User Manual page 314

Display item
M Reconstruction Rate
*3
N Spinup Delay *3
O NCQ *4
*1 This can be changed only when no disk arrays have been set at all.
*2 Do not use Set Factory Defaults. This setting must be changed to the recommended values.
*3 Change the value to the recommanded value.
*4 Always use the Default setting.
Place the mouse cursor on a setting item and left-

click the mouse to change the setting values. Or,
left-click the mouse to move the cursor and enter
a value from the keyboard. Click Submit after the
setting.
Values of Spin Drive Count and Spin Delay are

fixed, which will not take effect even though you
have changed the values.
Display/content
at system startup
Priority of capacity expansion
Timing for hard disk motors to start
at system startup
Setting the NCQ command
263
Setting/display value **
0 to 100 / [30]
0 to xxx / [6]
[Enabled] / Disabled